Home > Watch Tools & Accessories > How to Change a Watch Strap Without Scratching the Lugs


How to Change a Watch Strap Without Scratching the Lugs

A Citizen diver's watch on a black NATO-style fabric strap, shown from above
A diver's watch on a NATO-style fabric strap. Fabric straps thread under the spring bars. Photo: Francis Flinch, Public domain, via Wikimedia Commons.

A step-by-step guide to swapping a watch strap safely: the right tool, protecting the lugs, fitting the new strap and checking it is secure.

Section: Watch Tools & Accessories
Published:
Reading time: about 2 minutes
By the Steel Connect Journal editors

Article

Changing a watch strap takes two minutes once you know how, and most of the damage people do happens in the first ten seconds, when a sharp tool slips and drags across a polished lug. A little preparation avoids that.

What you need

  • A spring bar tool with a forked end and a pin end.
  • Low-tack tape (painter's tape works) to protect the lugs.
  • A soft cloth on a table, not your lap.
  • New spring bars in the right width, if the old ones are tired.

Removing the old strap

  1. Tape the lugs. Cover the inner faces and tips of the lugs where the tool might slip.
  2. Find the gap. Lay the watch face down. Between the strap and the lug you will see the end of the spring bar.
  3. Compress the bar. Slide the fork between strap and lug, catch the shoulder of the bar and push it towards the centre of the case.
  4. Tilt the strap out. As the pin clears the hole, rotate the strap away. Repeat at the other end.

On quick-release straps you skip the tool: pull the small lever and lift the strap out.

Fitting the new strap

  1. Slide the spring bar into the strap and seat one end in its lug hole.
  2. Compress the other end with the tool and lower it into place until it clicks into the hole.
  3. Wiggle the strap firmly. If it moves sideways or the bar shows, it is not seated.

Common mistakes

  • Working over a hard floor. Spring bars fly, and they are hard to find.
  • Using a kitchen knife. It slips and gouges.
  • Reusing a bent bar. Replace it; our spring bar guide explains sizes.

Watch people who work with small parts all day, from watchmakers to the technicians who service casino slot machines, and you will notice the same habits: a clean mat, good light and patience. They are worth copying for a job this small.

You May Also Like

Spring Bars Explained: Sizes, Shoulders and Quick Release

Watch Tools & Accessories · October 1, 2026

Smartwatches at the Poker Table: What Card Rooms Allow

Casino & Odds · October 21, 2026

316L, 904L and Titanium: The Metals in Your Watch

Watch Tools & Accessories · September 16, 2026