Home > Watch Tools & Accessories > Spring Bars Explained: Sizes, Shoulders and Quick Release


Spring Bars Explained: Sizes, Shoulders and Quick Release

An 1899 catalogue illustration of a watchmaker's lathe and a boxed set of attachments
A watchmaker's lathe and tool set from an 1899 catalogue of supplies for watchmakers and jewellers. Photo: Internet Archive Book Images, No restrictions, via Wikimedia Commons.

The tiny spring-loaded pin that holds almost every watch strap. Sizes, shoulder types, quick-release versions and how to choose the right one.

Section: Watch Tools & Accessories
Published:
Reading time: about 2 minutes
By the Steel Connect Journal editors

Article

Almost every watch strap in the world is held on by a spring bar: a thin tube with a spring inside and a small pin sticking out of each end. Push the ends in, line them up with the holes in the lugs, let go, and the strap is secured. Simple as it is, the right spring bar matters more than most people realise.

Length

A spring bar is sold by the width between the lugs: 18, 20, 22, 24 mm and the sizes between. The bar must match that width exactly. Too short and it can pop out; too long and it will not seat at all.

Diameter

Common diameters run from about 1.5 mm for dress watches to 1.8 mm or more for dive watches. Thicker bars are stronger but need a strap with a large enough channel. If a new strap will not slide onto the bar, the bar is probably too thick for it.

Shoulders

The "shoulder" is the step near each end that the tool catches on. Single-shoulder bars are standard. Double-shoulder bars have two steps, which gives a tool more grip in tight spaces and is useful with bracelets.

Quick-release bars

Quick-release spring bars have a small lever on one side. Pull it with a fingernail and the bar retracts, no tool required. They are now standard on smartwatch straps and many fashion straps. The trade-off is that the lever adds a little width, so they do not fit every tight strap channel.

Fat bars and screw bars

Some sturdier watches use extra-thick "fat" spring bars, or screw bars that thread right through the lugs. Screw bars are the most secure option but need a screwdriver to change the strap. Certain strap adapters used screw bars for exactly that reason.

Replace them

Spring bars are cheap and they wear. If a bar has been in and out many times or feels weak, replace it. A good tool helps; see our guide to changing a strap without scratches.

Losing a watch because of a tired fifty-cent spring bar is the worst bet you can make with your wrist. Keep a few spares of your widths in a drawer.

You May Also Like

316L, 904L and Titanium: The Metals in Your Watch

Watch Tools & Accessories · September 16, 2026

How to Change a Watch Strap Without Scratching the Lugs

Watch Tools & Accessories · August 17, 2026