Home > Smartwatch Adapter > Moto360 Strap Adapter > Moto 360: Why the First Round Smartwatch Needed Adapters


Moto 360: Why the First Round Smartwatch Needed Adapters

A first-generation Motorola Moto 360 worn on a wrist with a dark leather strap
The first Moto 360 had no visible lugs, which made changing straps harder. Photo: Raysonho @ Open Grid Scheduler / Grid Engine, CC0, via Wikimedia Commons.

The 2014 Moto 360 made round smartwatches fashionable, but its lugless case made strap swaps awkward. A look at the design and the adapters it inspired.

Section: Moto360 Strap Adapter
Published:
Reading time: about 2 minutes
By the Steel Connect Journal editors

Article

The Motorola Moto 360 arrived in 2014 as one of the first Android Wear watches with a round screen. Next to the square watches of the time, it looked like a proper watch, and that was the point. Its case had no visible lugs at all: the strap disappeared into the back of the case, giving a clean, pebble-like profile.

The cost of a clean look

Hiding the lugs meant hiding the spring bar too. The strap was held by a bar sitting in a recess under the case. In principle it accepted 22 mm straps, but in practice thicker leather, rubber with curved ends and most metal bracelets did not sit comfortably, and swapping straps was a test of patience. Many owners stayed with the stock leather until it wore out, then went looking for alternatives.

Adapter designs

Accessory makers offered several fixes. Some adapters clipped into the recess and presented ordinary lug holes, so any 22 mm strap would fit. Others were designed for a specific width, and a few turned the watch into something else entirely, such as a pocket watch or a pendant on a chain. The SteelConnect M-series adapters, sold in a couple of finishes and sizes plus a hook version, belonged to this wave.

When choosing an adapter for any lugless watch, look at:

  • Material and finish that match the case, usually stainless steel or PVD black.
  • Screw or pin retention. Adapters that rely on friction alone can work loose.
  • Total length. Adapters add a few millimetres at each end, which matters on small wrists.

What came next

Motorola's second-generation Moto 360 in 2015 added conventional lugs with quick-release pins, which says a lot about what owners had asked for. Today almost every round Wear OS watch uses standard 20 or 22 mm pins, and our guide to what fits Wear OS watches covers the details.

The first Moto 360 is a collector's curiosity now. Before buying one second-hand, check the battery and the strap recess for cracks; the price of an old smartwatch is a small gamble, but a cracked case makes the odds much worse.

You May Also Like

Pebble Steel and the Strap Adapter Problem

Pebble Steel Strap Adapter · October 26, 2026

Apple Watch Band Adapters: Slots, Lugs and Fit

Apple Watch Strap Adapter · October 16, 2026